**STEP n°4:** assemble Ohmpi 
****************************************************
   
.. table::
   :align: center
   
   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_1.jpg                         |
   |      1 +------------------------------------------------------------+
   |        |Cut 4 ribbon cables composed of 16 wires each to the proper | 
   |        |length (about 1.5m). Each wire corresponds to an electrode. |                                                                      
   +--------+------------------------------------------------------------+

.. table::
   :align: center

   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_2.jpg                         |
   |      2 +------------------------------------------------------------+
   |        |Crimp the ribbon cable on the corresponding idc connector   | 
   |        |with a suitable clamp. Pay attention to the direction of the|                                                                      
   |        |cables. Unbalanced IDC connector. The ribbon cable must be  | 
   |        |perpendicular to the connector.                             |
   +--------+------------------------------------------------------------+
   
.. table::
   :align: center

   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_3.jpg                         |
   |      3 +------------------------------------------------------------+
   |        |Example of IDC connector mounting. The wires should run as  | 
   |        |perpendicular as possible to the IDC connector.             |                                                                      
   +--------+------------------------------------------------------------+   
   

.. table::
   :align: center

   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_4.jpg                         |
   |      4 +------------------------------------------------------------+
   |        |Same for a 6 wires ribbon cable of 1 m length.              | 
   |        |                                                            |                                                                      
   +--------+------------------------------------------------------------+  

.. table::
   :align: center

   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_5.jpg                         |
   |      5 +------------------------------------------------------------+
   |        |Cut the ribbon cable flush with the IDC connector.          | 
   |        |                                                            |                                                                      
   +--------+------------------------------------------------------------+  

.. table::
   :align: center

   +--------+------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_6.jpg                         |
   |      6 +------------------------------------------------------------+
   |        |Position 9 spacers above the MUX board, and 9 spacers below.| 
   |        |                                                            |                                                                      
   +        +------------------------------------------------------------+
   |        |   .. image:: step_n_4/step_4_7.jpg                         |
   |        +------------------------------------------------------------+
   |        |Profile view for mounting the spacers above and below.      | 
   |        |                                                            |                                                                      
   +--------+------------------------------------------------------------+