Newer
Older
**STEP n°4:** assemble Ohmpi
****************************************************
.. table::
:align: center
+--------+------------------------------------------------------------+
| | .. image:: step_n_4/step_4_1.jpg |
| 1 +------------------------------------------------------------+
| |Cut 4 ribbon cables composed of 16 wires each to the proper |
| |length (about 1.5m). Each wire corresponds to an electrode. |
+--------+------------------------------------------------------------+
.. table::
:align: center
+--------+------------------------------------------------------------+
| | .. image:: step_n_4/step_4_2.jpg |
| 1 +------------------------------------------------------------+
| |Crimp the ribbon cable on the corresponding idc connector |
| |with a suitable clamp. Pay attention to the direction of the|
| |cables. Unbalanced IDC connector. The ribbon cable must be |
| |perpendicular to the connector. |
+--------+------------------------------------------------------------+